Product details
Sand-colored snake scales with black blotches, each one rimmed in orange.
People look at a prosthetic leg anyway. Give them something worth looking at. This cover is a printed stretch tube for the outside of a below-knee prosthesis. It goes on last, over everything else. Pull it on, pull it off, wash it, swap it for another print tomorrow.
About the Snakeskin print
Up close the scales are small, rounded and overlapping, shaded from sand to cream, and the black blotches have stepped, pixel-like edges instead of smooth ones. It reads as a western or desert print, so it goes with denim, tan and brown leather. Wear it to a rodeo, a country concert or on a desert road trip. The same print comes on our Snakeskin Crew Socks and Snakeskin Shorts.
Before you order: measure first
- With the prosthesis on, the way it is worn, measure the socket at its widest point. If the cover will go over a suspension sleeve, measure over the sleeve. Then measure the length to cover and check the size guide.
- It stretches in every direction, but the maker doesn’t publish a maximum stretch. Between sizes, or is the socket’s widest point over 19 in? Email hello@loudlimb.com the numbers before you order.
- It’s decorative apparel, not a medical device. It doesn’t treat or support anything.
- The blank is the same midweight stretch tube that’s sold as a neck gaiter.
How to wear it
- Put the prosthesis on the way a prosthetist showed you, with the liner, socks and suspension sleeve as usual.
- Pull the cover on last, over the outside.
- Never put the cover under a suspension sleeve or inside the socket.
- Keep it clear of valves, pin-lock release buttons, lanyards and anything that bends or moves. Never pull it over a knee joint.
- If anything changes how the prosthesis feels or moves, take the cover off and ask a prosthetist.
Specs
- Sizes: S, M, L.
- Relaxed circumference: about 16.5 in (S), 18 in (M), 19 in (L). That’s the flat width doubled, before stretching.
- Length: 15 in (S), 16.5 in (M), 17.5 in (L).
- Measurements can vary by about 0.5 in.
- Fabric: 90% polyester, 10% elastane, 250 g/m², four-way stretch, white inside.
- Printed front and back by dye sublimation.
- Imported blank, printed to order in the USA.
- Usually goes to print within a business day and prints in 1 to 2 business days. See the shipping page for delivery times.
Care
- Machine wash warm, up to 105°F (40°C).
- Tumble dry low.








